Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Fast, Reliable Garage Door Installation Across Commerce City
A new garage door installation in Commerce City typically runs $700-$2,200, depending on size, material, and whether you’re replacing a single, double, or custom door. If you need garage door repair in Commerce City instead, we handle that too. We schedule free in-home measurements across Commerce City every week, and you’ll get a flat, written price before any work starts, not a vague “call us” range. If you’re off Highway 2, near Reunion, or down in the older south corridor, call (720) 575-1024 and we’ll come out, measure what’s there, and hand you a price on paper.
Commerce City isn’t Denver, and it isn’t Thornton. The air chemistry here is different, and the hail tracks are different. We account for both when we spec a door. That’s the whole point of this page.
Why Servo Garage Doors Thornton Is Commerce City’s Preferred Garage Door Installation Company
The honest answer is paperwork. When our technicians walk your garage in Commerce City, they photograph the existing setup, measure the opening, and document what they find before quoting anything. That’s Clause 4 of The Haven Standard, the set of written rules Servo has operated under since 2015. You see the condition of your tracks, springs, and framing at the same time we do. If we recommend a replacement, you’ll know why, because the photo record shows you the corrosion or fatigue that’s driving the recommendation.
Marcus Deller set the tone early: no urgency pitches, no “sign today” pressure. Just a written scope, a written price, and a documented record when the job closes. Every installation in Commerce City ends with a photo file showing the new door in place, the hardware we used, and the work we performed. That file is yours. We don’t keep it as a sales tool.
Our crews know the housing stock in Commerce City because they drive it every week. The north side, up through Reunion and the neighborhoods off Tower Road, is mostly 2004-2014 construction with original torsion systems now aging into replacement. The south corridor, down toward the 80022 zip, is a different animal entirely: smaller single-car garages, older framing, opener brackets that were installed when a 7-foot steel door was standard. Those two areas need different conversations. We have both of them.
All Servo technicians are background-checked and uniformed. The company is independently owned and operated under The Haven Standard, a local business holding its own license and insurance. When you call (720) 575-1024, a person answers. Not a recording, not a callback window.
Our Garage Door Installation Services in Commerce City

We install full door systems, not just panels on existing hardware. Every job starts with a measurement and a written quote. Here’s what we do most often in Commerce City, and what drives those jobs locally.
New Door Installation
A full new door installation means removing the old door and hardware, inspecting the framing, and setting a new door, tracks, springs, and cables to spec. In Commerce City, we check the existing torsion spring cycles and cable condition as part of the quote, because homes downwind of the refinery often need that hardware replaced even if the door panel itself is still straight. A new door on corroded springs is a future service call, and we’d rather show you that on the front end. New door installation in Commerce City runs $700-$2,200 depending on size, insulation, and wind rating.

Single Car Door
The older homes south of Highway 224 and along the industrial corridor have a lot of narrow single-car openings, often 8×7 or 9×7. These doors need careful track placement, and we frequently find the original opener brackets pulling loose from the frame, which compounds every time the door cycles. Single-car installations are straightforward, but the framing inspection is where we earn the job. We quote them flat, just like every other door.

Double Car Door
Double-car doors dominate the northern half of Commerce City, especially through Reunion and the subdivisions along East 104th Avenue. These are usually 16×7 doors on torsion systems, many now hitting 15-20 years on original hardware. If your double door is heavy to lift by hand, that’s not normal; it means the springs are losing tension or the cables are binding. We’ll show you the measurements before we quote a replacement.

Custom Garage Door
Custom doors are where Commerce City gets interesting. Some homeowners around Reunion want a specific look that matches the HOA’s architectural guidelines, and that can mean specific panel profiles, window placements, and wind-rated construction. We order custom dimensions and configurations from Clopay and Amarr, and we’ll walk you through the lead time and the exact cost before you commit to anything. Custom work runs toward the higher end of the $700-$2,200 range, but you’ll know the number before the order goes in.
Our Garage Door Installation team carries galvanized hardware, high-cycle torsion springs, and wind-rated reinforcement kits on the truck, so most Commerce City jobs close in a single visit.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Before
AfterTrusted Brands We Service in Commerce City
We install and service LiftMaster, Chamberlain, Genie, and Clopay, among others. For Commerce City specifically, we tend to recommend Clopay’s wind-rated steel doors for north-side homes that sit in the open hail corridors, and we pair them with high-cycle torsion springs that outlast the sulfur-corrosion curve. If you already have a brand preference, we’ll quote it. If you want our honest take on what holds up against Commerce City’s particular weather and air chemistry, we’ll give you that too, in writing, with the price.
Common Garage Door Installation Problems We See in Commerce City Homes

- Premature torsion spring failure from refinery-adjacent sulfur corrosion. Springs rated for 10,000 cycles are snapping well before that in the neighborhoods directly northeast of the Suncor facility. The sulfur compounds in the air pit the spring wire and accelerate fatigue. We photograph the failed spring before quoting a replacement, so you see the pitting yourself.
- Track misalignment after Front Range hail events. Commerce City sits in a high-hail-frequency zone, and baseball-size hail dents steel panels and can knock tracks out of true. A door that binds or scrapes after a storm likely has track damage, not just panel damage. We check both, because fixing one without checking the other leaves the door running against itself.
- Legacy opener brackets pulling loose on 1950s-1970s south-corridor homes. The older single-car frames along the southern half of Commerce City were built for lighter, thinner doors. Modern openers put more torque on the bracket, and we see them pulling away from the studs, especially on windy days. This gets documented in the quote, not discovered mid-job.
- Original hardware hitting end-of-life all at once in Reunion. Thousands of homes built 2004-2014 are aging into their first major mechanical service cycle on the same timeline. When we replace a door on one street, we’ll often find two or three neighbors with the same builder, same spring gauge, and same imminent failure. That clustering is unique to Reunion’s phased construction.
Pricing for Garage Door Installation in Commerce City, CO
Here’s what we quote in Commerce City, and what drives the number up or down. Every price below is a flat, written range you’ll get confirmed before any work begins, per Clause 1 of The Haven Standard. No “subject to change once we open it up.” The quote is the quote.
| Service | Price Range in Commerce City |
|---|---|
| New Door Installation | $700-$2,200 |
| Spring Repair | $180-$340 |
| Cable Repair | $130-$250 |
| Track Realignment | $120-$240 |
What moves a new door installation toward the top of that range: double-car width, custom panel profiles, insulation upgrades, wind-rated reinforcement, and any framing repair the photos show us. What keeps it low: a standard 9×7 or 16×7 steel door on straight tracks with good framing. We’ll tell you which one you’re looking at, and we’ll put the number on paper. Estimates in Commerce City are free.
What Commerce City’s Air and Hail Mean for Your Door Spec

Commerce City sits immediately downwind of the Suncor refinery, one of the largest in the Rockies. Elevated hydrogen sulfide and sulfur dioxide levels in the air here measurably accelerate corrosion on torsion springs, cables, and galvanized tracks. That’s not a theory; it’s visible on the hardware we pull out of homes along East 96th and Tower Road. The springs pit. The cables fray at the drum. The tracks lose their zinc layer in patches. A replacement interval that makes sense in Thornton or Aurora is often too long for a home sitting directly in the refinery’s downwind plume.
Now layer in hail. Commerce City sits in the Denver metro’s high-hail-frequency band, and severe storm cells roll through the Front Range here with enough energy to dent and crack steel panel doors. When a door takes hail damage, the panels are the visible problem, but the impact energy often throws off track alignment and stresses the spring system. A door that’s already fighting corrosion and then takes a hail hit is a door that fails early unless the installation accounted for both forces.
The combination is what we design around on every Commerce City installation. We don’t sell the same door we’d sell in Westminster. We spec high-cycle torsion springs, galvanized cables rated for chemical exposure, and wind-rated panels when the home sits in an open corridor.
A Reunion Street, Last Spring
We replaced a 2008-era double sectional door in the Reunion subdivision last spring where the original torsion spring had snapped after roughly 7,000 cycles, well short of its 10,000-cycle rating. The sulfur-driven corrosion had pitted the spring and cables, and the door’s track alignment was off by nearly half an inch. We installed a high-cycle torsion spring, new galvanized cables, and a wind-rated Clopay door with an R-value of 12.2. Then we called three neighbors on the same street to offer spring-cycle assessments. Same builder, same build year, same original spring gauge. Two of them had the same pitting. That’s a Commerce City pattern, not a coincidence.
This is why our Garage Door Installation team documents everything before quoting. You see what we see. No one guesses at a $1,400 door. The photos decide.
We Also Serve Cities Near Commerce City

We run installation crews through Thornton, Aurora, Westminster, and Denver on a regular schedule, but our Commerce City customers get the same flat written pricing and documented photo record as everyone else. If you’re on the edge of Commerce City and wondering whether we cover your street, call and ask. The answer is almost always yes. For full details on the areas we cover, see our Garage Door Installation in Commerce City service area page.
Serving Commerce City, CO - Our Local Coverage Area
We’re based in the Commerce City area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Garage Door Installation in Commerce City

If your home sits in an open corridor, especially in the northern half of Commerce City around Reunion and along Tower Road, a wind-rated door is worth the additional cost. Standard residential doors typically handle wind pressures up to a baseline rating, but wind-rated doors add reinforcement struts and heavier bracing that hold up better to the Front Range’s high-wind events. Homes with attached garages facing open prairie or with no tree cover are the most exposed. We’ll tell you honestly if your home needs it or not, because the photo record and the site survey show us the exposure you’re dealing with. Call (720) 575-1024 for a free measurement and a written spec.
Because of the sulfur compounds in the air. Commerce City sits downwind of the Suncor refinery, and the hydrogen sulfide and sulfur dioxide levels measurably accelerate corrosion on torsion spring wire. Springs rated for 10,000 cycles are pitting and snapping at 7,000 in the neighborhoods closest to the facility. That’s why we spec high-cycle springs on nearly every Commerce City installation, and why we photograph the old spring before quoting a replacement, so you can see the corrosion for yourself. Call (720) 575-1024 and we’ll assess your current springs at no cost.
A standard torsion spring is rated for roughly 10,000 open-and-close cycles, while a high-cycle spring runs 25,000 to 50,000 cycles depending on the gauge and design. In Commerce City, the sulfur exposure shortens standard spring life, so a high-cycle spring effectively buys back the lifespan you’d otherwise lose to corrosion. The cost difference is usually $50-$120, which is less than the cost of a single spring replacement service call. We recommend high-cycle springs on every Commerce City door we install or repair. Call (720) 575-1024 and we’ll quote the exact spring for your door, in writing.
If the door binds, scrapes, or shifts when opening after a hailstorm, the tracks likely took impact energy and need realignment, which we do for $120-$240 in Commerce City. If the panels show visible dents, cracks, or punctures, they need replacement, which runs $250-$500 per panel depending on the door. Often both are needed, because the same impact that dents a panel also throws the track out of true. We’ll assess both in the same visit and photograph the damage before quoting anything. Call (720) 575-1024 to schedule a post-storm inspection.
No. The price we quote is the price you pay, and that price is written and delivered before any work begins, per Clause 1 of The Haven Standard. We don’t quote a low number to get in the door and then “discover” problems. If our technician sees something that changes the job scope, the quote changes in writing before we touch anything, and you approve it first. Every Commerce City installation closes with a documented photo record, so there’s no ambiguity about what was found and what was done. Call (720) 575-1024 for a free estimate.
Call Servo Garage Doors Thornton for Garage Door Installation in Commerce City
If you’re reading this because your garage door needs replacing, you’ve already done the research. The next step is a measurement and a written price. We’ll come to your home in Commerce City, document what’s there, and hand you a flat quote you can think about. No pressure, no deadline, no “this price is only good today.” That’s not how we work. Call (720) 575-1024 and Marcus Deller or one of our technicians will get you on the schedule.
Written by Marcus Deller, Owner at Servo Garage Doors Thornton, providing garage door installation and repair across Commerce City under The Haven Standard.






Before
After
Before
After